Press and hold the power key to power on the device

• 

  During power on,The device display the CUB logo.

• 

  Software revision number follows after the CUB logo.

• 

  Now the device is at the maker selection menu

Use arrow key to scroll up and down between maker

• 

  Maker selection: Use the arrow key to browse alphabets of car-makers, press the -Enter- key to select

• 

  Maker selection: Use the arrow key to browse automakers, press the -Enter- key to select

• 

  Model Selection: Use the arrow key to browse models, press the -Enter- key to select

This function is designed for you to bypass OBD II and automatically duplicate an O.E Sensor.

• 

  Maker selection: Use the arrow key to select year and frequency and press the -Enter- key to select

• 

  Function selection: Use the arrow key to select new sensor and press the -Enter- key to select

NOTE - Duplicate and Program function will only work with CUB's Uni-sensor and Uni-sensor only.

• 

  Function selection: Use the arrow key to select manual duplicate and press the -Enter- key to select.

• 

  O.E ID Locator: Use the O.E ID Locator to help find the Sensor ID on a dead O.E sensor. press the -Enter- key to select

• 

  Manufacture Selection: Use the arrow key to select the manufacturer of the O.E sensor. press the -Enter- key to select

• 

  ID Locator: This will show you where the ID is located some manufacturer may have more than one type of sensors. Use the arrow key to browse, to go back press the Esc key

• 

  Input ID: Use the Input ID function will allow you to input the ID from O.E Sensor to program the Uni-sensor, press the -Enter- key to select

• 

  Input Sensor ID: Use the arrow key to browse, press the -Enter- key to enter the ID Please check if OE sensor ID is Hexdecimal (0~9 + A~ F ) OR Decimal (0~9) to select correct mode in Manual Duplicate.